Strong Hd Digital Satellite Receiver Update With Flash Drive

Strong Digital Satellite Receiver Update With Flash Drive

This post is a complete guide in which you will be learning about all the information to update strong decoder software with a USB flash drive and important questions about strong decoders. You need not to ask questions about it which may give you confusing and irrelevant answers, because the complete detail is here now which you was looking for. There are many other decoders that are available in the market but you can buy the best one by checking or asking here in the comments boxes.

Before you start the update you need to have these things in around you so that you can complete your task without any problem, if you don’t have then you can buy from any computer hardware shop that will guide you as well what to buy and what to not. Nevertheless here are the things required for software you want to update with USB (Universal Serial Bus).

I. A strong decoder

II. One USB flash drive which is free from virus and free from data.

III. The original software for your decoder from strong official website HERE

IV. Make sure you have a stable electric power supply or supply or beta still use a generating set otherwise you may kill your decoder if there is a power failure

There are the compulsory things that you need in that place where you have placed you’re the equipment and below are the steps to upgrade strong decoder software with a USB flash drive and important questions about strong decoders.

The easy way to identify the price of a Strong product

Please make sure that the plug is properly inserted into the socket and that the socket is switched on. If it is, unplug the power cord for about 30 seconds before plugging it back in. If the light does not come on, and the unit is not working, contact your local Strong dealer or point of sale

The adjustment of a PIN Number

Press menu=> go to “System Settings” => “Security Setting” => enter the old password then go to “Current Password” and enter the old password, then type the new password under “New Password” then type again the new password under “Verify Password” Press “Exit” to exit menu

If “No Signal” or “Bad Signal” message appears on the screen

This indicates no signal or a poor signal is being received. Please note that this may be normal under bad weather conditions. If this is not the case, please press the MENU key on the remote control handset and check the ‘Signal Quality’. If there’s no signal graphic bar, check the antenna condition and the connection between the satellite dish and the receiver. Make sure that you have selected the correct satellite in the Menu. If the bar is present, please check the parameters settings via the Installation Menu.

The STB power is ON, but the RF Modulator is not functioning

Check the connections, and connect the unit’s RF-OUT to the TV set’s Antenna IN. Also check the RF output type and channel number in the System Menu. If still not working, try to reset your receiver by disconnecting the power plug for about 30 seconds and then reconnecting it. If still not working, please contact your local Strong dealer or point of sale.

If problem occurs with the unit of remote control?

Try replacing the batteries of your handset. If that does not solve the problem, the handset may require service

If there is no sound but the screen is displaying

Please check the RCA and SCART connectors and check on both the TV set and the STB if “MUTE” mode is selected and if volume is at its lowest level. Also, check the audio track by pressing the AUDIO key

Method of downloading software for your receiver

If the software version available for your receiver is newer than the version that you are currently you should download the new version.

Now you are all done with everything and you are ready to view the upgraded software. This easy method to update strong decoder software with a USB flash drive and important questions about strong decoders is the best and you can recommend others too to save their time.